Machine Collects some used abrasive during cutting. Tank-cleaning cycles are needed afterwards to collect additional abrasive.
Uncollected abrasive on the bottom of the tank can clog the abrasive collection ports, requiring draining the tank and scooping out the abrasive by hand. The machine will continue to cut even if the abrasive collection ports are clogged, and the used abrasive will accumulate on the bottom of the tank. Learn more about WAZER’s abrasive collection system.
Check that the bed is level to the gantry and Level if necessary
Brush all excess sand into tank
Turn on Wazer
Run HP valve check to prime HP line
a. Remove abrasive hose
b. Select Maintenance>Input/output check>Output>HP Valve
c. Blow out abrasive hose with air
d. Blow out abrasive inlet on nozzle
e. Check the rubber abrasive catcher is dry and securely attached.
f. Reattach abrasive hose on both ends. Only inserts about ¼"
Select cut file
Follow all on screen instructions
Move origin if necessary
Check cut extents
Cut file
Run Tank Cleaning Cycle after EVERY cut
a. Maintenance>Tank Cleaning