Check coolent tank and make sure it's full!
Turn on the air compressor in the metalshop closet
Turn on large switch on side of fadal.
Perform a visual inspection of the machine
Home the Machine
CS command cold starts the machine (sets it's home position)Warm up the spindle (must be re-done if machine has been idle for more than 4hrs)
Move the machine around the table to check for proper movement.
[command comming soon][command comming soon][Comming soon]
[Comming Soon]
[Comming Soon]
[Comming Soon]
Remove workpeice and all scrap
Vacuum worktable
Mop and Sweep around the Fadal!
Use HO command to move the Fadal to it's home position
Turn the main switch to the off position
Close air valve behind the Fadal
Turn off air compressor (first check if anyone us using it)